News Center

The company has established the enterprise goal of "survival by quality, reputation by quality, and development by quality. Strengthen the training of technical personnel, and constantly enrich the first-line technical force to ensure the normal operation of the quality assurance system.

Introduction to the System Composition of Homogenizing Emulsion Machine

Release time:


1.The structure of the stirring paddle of the slow mixing system is of frame type and double stirring type. The middle blade and the rotating paddle of the frame wall are convective stirring, and the working speed of the rotating paddle should be15-60r/min range.

Speed is too slow: the reducer fever serious.

Too fast: the speed reducer is damaged and accelerated.

The bracket plate is made of polytetrafluoroethylene, which is adjusted to be flat against the wall of the pot for heat exchange.

1 Two counter-rotating low-speed mixing systems. It consists of a hanger and blade covered with scrapers.

2 The fully automatic movable scraper is made of PTFE material, which can only work when there is material, and is easy to disassemble and clean.

3 concentric axes for dynamic balance.

4 The external hangers and internal blades are made of stainless steel SUS316L.

5 The electronic timer is installed on the PLC to facilitate the adjustment of working time.

6 Equipped with a geared motor-produced by ABB, the speed can be directly adjusted by the inverter, the speed is 0-80 rpm/min.

2.Fast Homogeneous Mixing System

1 The rapid homogenization mixing action is performed by a turbine installed in the center of the tank bottom.

2 The turbine consists of a toothed stator and a rotor with blades.

3 The turbine is made of SUS316L stainless steel, and the rotating part is passed through a concentric shaft with dynamic balance.

4 The electronic timer is installed on the PLC to adjust the processing time.

5 equipped with deceleration motor -- ABB company production, using frequency conversion speed regulation, speed 0-3000r/min

3.Heating/Cooling system

1 heating by the external steam through the jacket to the inner tank heat transfer.

2 The water temperature in the jacket is controlled from the PLC through the temperature controller.

3 The temperature control consists of an electronic temperature control controller and a galvanic couple installed at the bottom of the tank, which can accurately read the actual temperature of the material.

4 Cooling is done directly by external cold water through the jacket.

4.Vacuum system

1 water ring vacuum pump.

2 The vacuum gauge indicates the vacuum in the body,

3 The vacuum safety switch is designed to avoid the operation of opening the upper cover under vacuum.

4 The air tightness of the upper cover is guaranteed by the silicon filler on the flange.

5 In theory, the maximum vacuum degree is 730mm/hg at 20 ℃. In order to obtain a perfect emulsification effect, air must be avoided from entering the material. Processing under vacuum allows direct injection of liquid or powder into the volume.

5.The lifting and lowering of the upper cover is completed by a group of hydraulic devices, equipped with a safety limit system, which can keep the upper cover in any desired position.

6. container pouring system The container pouring system is used for unloading and is completed by a manual runner and stays at any angle. The 7. processing control observation window is equipped with cleaners and lights, and has good internal visibility. I believe that through the above introduction, we have been onHomogenizing emulsifying machineThe system composition of the understanding of it.