News Center

The company has established the enterprise goal of "survival by quality, reputation by quality, and development by quality. Strengthen the training of technical personnel, and constantly enrich the first-line technical force to ensure the normal operation of the quality assurance system.

Daily maintenance of magnetic seal stainless steel reaction kettle


Release time:

2019-07-18

Magnetic sealing stainless steel reaction kettle should be properly checked and maintained after a period of time. The magnetic sealing stainless steel reaction kettle should be cleaned. After the kettle body is dried, the sealing inspection should be carried out first. Put the kettle body into the heating furnace, place the protruding part in line with the groove, gently spin the kettle body, and slowly and steadily close the kettle body with the kettle cover after placing it stably. Special attention should be paid to protect the sealing surface to avoid damage caused by collision between the kettle cover and the sealing ring of the kettle body. After covering, check whether the upper and lower interfaces of the stainless steel reaction kettle are aligned, gently turn the kettle cover to confirm that the kettle cover has been laid flat and the sealing ring is in good contact. After adding the gasket, open the kettle.

magnetic sealStainless steel reaction kettleAfter using a period of time should be appropriate for simple inspection and maintenance, magnetic sealStainless steel reaction kettleAfter the use of cleaning, the kettle body should be dried, the sealing check should be carried out first. Put the kettle body into the heating furnace, place the protruding part in line with the groove, gently spin the kettle body, and slowly and steadily close the kettle body with the kettle cover after placing it stably. Special attention should be paid to protect the sealing surface to avoid damage caused by collision between the kettle cover and the sealing ring of the kettle body. After the cover, should be checkedStainless steel reaction kettleCheck whether the upper and lower joints are aligned, gently turn the kettle cover to confirm that the kettle cover has been laid flat and the sealing ring is in good contact. After adding the gasket, start to screw.

On the screw note

When screwing, be sure to seat the screws, tighten them by hand first, and then use a torque wrench to form a cross-shaped symmetrical ground to avoid uneven force. Do not twist the screws in place at one time, tighten the diagonal screws several times, and tighten them symmetrically step by step.