News Center

The company has established the enterprise goal of "survival by quality, reputation by quality, and development by quality. Strengthen the training of technical personnel, and constantly enrich the first-line technical force to ensure the normal operation of the quality assurance system.

Buy vacuum emulsifying machine need to pay attention to what


Release time:

2019-06-27

Methods Turn on the power supply of the vacuum emulsifying machine, the power supply is consistent, and pay attention to the reliable grounding of the ground wire, turn on the main power switch, turn on the power supply of the controller, and the indicator light is on. Correctly connect all pipes of the homogenizing pot (including all overflow ports, drain ports and sewage outlets). Before vacuuming, it is necessary to check whether the pan of the vacuum emulsifying machine is flat with the pan cover, whether the pan mouth and the material port cover are tightly covered and reliably sealed. Close the valve interface on the lid, then open the vacuum valve on the lid, then open the vacuum pump to vacuum, close the vacuum pump when the requirements are met, and close the vacuum valve at the same time. (See the operation process flow chart for details) Homogeneous cutting and scraper stirring: after feeding (during debugging, you can

Method

ONvacuum emulsifying machinePower supply, power supply match, and pay attention to the reliable grounding of the ground wire, turn on the main power switch, turn on the controller power, the indicator light is on.

Correctly connect all pipes of the homogenizing pot (including all overflow ports, drain ports and sewage outlets).

Be sure to check before vacuumingvacuum emulsifying machineWhether the pot is flat with the lid, whether the lid of the pot mouth and the lid of the inlet are tightly covered and sealed reliably. Close the valve interface on the lid, then open the vacuum valve on the lid, then open the vacuum pump to vacuum, close the vacuum pump when the requirements are met, and close the vacuum valve at the same time.(See operation process flow chart for details)

Homogeneous cutting and scraper stirring: after feeding (during debugging, water can be used instead ) Then turn on the corresponding control switch to control the operation of the homogenizer and the operation of the scraper stirring. Before the start of stirring, it should also be inched to check whether there is any abnormality in the stirring scraping wall, and if so, it should be eliminated immediately.

The vacuum pump can only be started when the homogenizing pot is sealed. If there is a special need to open the air to start the pump, it cannot be operated.3 minutes.

The vacuum pump is strictly prohibited from running without working fluid. Do not block the exhaust port when the pump is running.

Regularly check the lubricating oil and grease in each component and bearing, and replace the lubricating oil and grease in time.

Keep the homogenizer clean. Every time you want to stop using or replace the material All parts of the homogenizer in contact with the working fluid should be cleaned, especially the cutting wheel cutting sleeve of the head, the sliding bearing and the shaft sleeve in the homogeneous shaft sleeve. After cleaning and reassembling, the hand-rotating impeller shall be free of jamming. After the two flanges of the pot body and the pot cover are relatively fixed, the homogenizer motor shall be inching. Only when the direction is correct and there are no other abnormalities can the operation be started.

Allvacuum emulsifying machineThe cleaning work is handled by the user according to the standard.