News Center

The company has established the enterprise goal of "survival by quality, reputation by quality, and development by quality. Strengthen the training of technical personnel, and constantly enrich the first-line technical force to ensure the normal operation of the quality assurance system.

Tips for operating cosmetic equipment vacuum homogenizing emulsifying machine


Release time:

2019-05-06

1, homogeneous cutting head due to the high speed, not in the empty state of operation, so as not to affect the degree of sealing after local heating. 2. The homogenizer of the vacuum emulsifier is reversed from top to bottom. After the motor is wired or not to be restarted for a long time, it should be inching and tested. The turning of the mixing frame is reversed from top to bottom, and the mixing blade is reversed from top to bottom. 3. Homogeneous cutting and scraper stirring of vacuum emulsifier: after feeding (water can be used instead during debugging), the corresponding control switches are turned on to control the operation of homogenizer and scraper stirring. 4, vacuum emulsifying machine pay attention to keep the homogenizer clean. If stop

1, homogeneous cutting head due to the high speed, not in the empty state of operation, so as not to affect the degree of sealing after local heating.
2. The homogenizer of the vacuum emulsifier is reversed from top to bottom. After the motor is wired or not to be restarted for a long time, it should be inching and tested. The turning of the mixing frame is reversed from top to bottom, and the mixing blade is reversed from top to bottom.
3. Homogeneous cutting and scraper stirring of vacuum emulsifier: after feeding (water can be used instead during debugging), the corresponding control switches are turned on to control the operation of homogenizer and scraper stirring.
4, vacuum emulsifying machine pay attention to keep the homogenizer clean. If the material is stopped or needs to be replaced, the part of the homogenizer in contact with the working fluid should be cleaned as required, especially the cutting wheel cutting sleeve of the head, the sliding bearing and the shaft sleeve in the homogeneous shaft sleeve. After cleaning and reassembling, the hand-turned impeller shall be free of jamming. After the two flanges of the pot body and the pot cover are relatively fixed, the inching homogenizer motor can turn correctly and start operation without other abnormalities.
5. During debugging, the homogenizer shall be operated after inching and stirring for trial rotation, and then the homogenizer shall be operated after confirmation.