News Center

The company has established the enterprise goal of "survival by quality, reputation by quality, and development by quality. Strengthen the training of technical personnel, and constantly enrich the first-line technical force to ensure the normal operation of the quality assurance system.

Precast method of tank wall plate for stainless steel storage tank


Release time:

2019-05-06

Stainless steel storage tank is a single-layer or multi-layer vertical or horizontal structure of sanitary and clean stainless steel container equipment. It is a commonly used liquid storage equipment in biological engineering, food, beverage, fruit wine, condiment, chemical industry, oil and other industries. The prefabrication methods for tank wall panels of stainless steel storage tanks are as follows: 1. For storage tanks with a diameter of less than 25 meters, the wall panel width shall not be less than 1000mm and the length shall not be less than 1000mm; 2, the diameter of the tank is greater than or equal to 25 meters, the wall width shall not be less than 1000mm, the length shall not be less than 2000mm; 3, the bottom ring wall plate longitudinal weld and tank bottom marginal plate butt welding

Stainless steel storage tank is a single-layer or multi-layer vertical or horizontal structure of sanitary and clean stainless steel container equipment. It is a commonly used liquid storage equipment in biological engineering, food, beverage, fruit wine, condiment, chemical industry, oil and other industries.
The prefabrication methods for wall panels of stainless steel storage tanks are as follows:
1. For storage tanks with a diameter of less than 25 meters, the width of the wall plate shall not be less than 1000mm and the length shall not be less than 1000mm;
2. For storage tanks with a diameter greater than or equal to 25 meters, the width of the wall plate shall not be less than 1000mm and the length shall not be less than 2000mm;
3. The interval between the longitudinal weld of the wall plate of the bottom ring and the butt weld of the marginal plate of the tank bottom shall not be less than 300mm, and the interval between the longitudinal seam of the wall plate of the upper and lower rings shall not be less than 500mm;
4. The interval between the edge of the tank wall opening receiving or opening receiving reinforcing ring plate and the longitudinal circumferential seam of the tank wall shall be greater than 8 times of the welding leg scale and not less than 250mm.